Minolta PageWorks Pro 18L Manuel d'utilisateur

PageWorks 18L

8When the Error LED is onPaper Misfeed 1 Paper Misfeed 2A paper misfeed occurred near the multipurpose tray.See page 6-7 or 6-21 of the User’s Manual.

9When the Error LED is onI/O Error (Parallel) I/O Error (Network)A controller error occurred at the parallel port.See page 6-24 of the User’s Manual.A

10Fatal ErrorRequires servicing.Turn the power to the printer off and then on again. If the same LED mes-sage continues to be displayed, contact your

111.With both hands, gently bend the face-down tray inwards and insert one of its tabs into its holder on the upper portion of the printer. Continue t

122.Using the left and right slots in the printer as guides, gently push Tray 1 until it cannot be inserted any further (as shown in the illustration)

131.Remove the tray cover from Tray 1.Loading PaperStep 32.Open all three of the paper size guides.3.Place the paper stack onto the tray, print-side u

14Connecting the Power CordStep 41.Make sure that the printer’s power switch is in the O (Off) position.2.Connect one end of the power cord that comes

151.Make sure that the printer and the computer you are connecting it to are both turned off.2.Connect one end of the interface cable to the parallel

16Install the printer driver to control the printer from your computer.You can install the printer driver for Windows 95, Windows 98 or Windows NT 4.0

17Windows NT 4.0Installing from the CD-ROM (Auto Run)1. Turn on your computer and start up Windows NT 4.0.2. Insert the Printer Driver CD-ROM into you

Step 1Unpacking the Printer ... 1Reference 1Printer Parts... 3Reference 2Control Panel ...

18Clearing a Paper MisfeedRemove the misfed sheet of paper by pulling it in the direction indi-cated by the arrow.Troubleshooting Reference 3Face-down

19Clearing a Paper MisfeedCaution• The fusing unit inside the printer can become very hot during operation.Do not touch the area to avoid injury.• Do

20Solving Print Quality Problems• Remove the imaging cartridge and gently shake it a few times to dis-tribute remaining toner.• Remove the imaging car

MEMO

MEMO

MEMO

Copyright1999 MINOLTA CO., LTDPrinted in JapanThe information contained in this manual issubject to change without notice toincorporat

1Before operating your printer, read the Set-Up Instructions carefully from cover to cover. Use this guide for reference.1.Take the items and accessor

23.Pull out the plastic-lead strip from the paper feed inlet.4.Remove the tape strip from the back of the printer.Step 1

3Printer PartsReference 1Control panelFace-down trayPaper size guideManual feed trayTray coverTray 1(multipurpose tray)Paper size guideTop cover relea

4The control panel has four indicator lights and one button.NoteOn or blinking Ready LEDSee the explanation for Ready on the LED chart. ☞p. 5On or bli

5When the Ready LED is onReady Power SavePrinter is ready and able to print.See page 6-16 of the User’s Manual.Printer has entered the Power Save Mode

6When the Ready LED is onWait Action Size MismatchPress the Action key in the event of a paper size error or when operating in the manual mode.See pag

7When the Error LED is onBuffer Overflow Cover OpenThe buffer cannot handle the volume of data being sent.See page 6-20 of the User’s Manual.The cover