Minolta Dimage Dimage X Manuel d'instructions télécharger pdf

DiMAGE X1 Camera Firmware Ver.1.10

This section explains how to install DiMAGE X1 firmware version 1.10. (Firmware is soft-

ware used internally to control the camera.) Be sure to read through the following explana-

tion before you install the firmware. Do not turn the camera OFF during installation; doing

so could damage the CPU inside the camera.

Contents of update

1. Shortened shutter-release time lag.

(Time period from when the shutter-release button is pressed down fully to when exposure

begins.)

2. Shortened operation time lag.

(Time period from zooming lever is operated to when operation of any other function button

is accepted.)

Target products

This firmware is for use only with the DiMAGE X1 and cannot be used with other products.

If the firmware version is already Ver.1.10, it is not necessary to update the firmware.

(Check the firmware version as shown below.)

www.konicaminolta.com

www.konicaminoltasupport.com

X1_FW_upd110_GB_r4.qxd 29.09.2005 16:26 Uhr Seite 1

1 2 3 4 5 6 7 8

How to update firmware 6

Résumé du contenu

Page 1

DiMAGE X1 Camera Firmware Ver.1.10This section explains how to install DiMAGE X1 firmware version 1.10. (Firmware is soft-ware used internally to cont

Page 2

1. Press the main switch (a) to turn on the camera.2. Press the menu button (b) to open the recordingmenu.3. Press the left/right keys of the controll

Page 3

A downloaded file must be copied to a Secure Digital (SD) memory card by either methods asshown below.Prepare an 8MB or larger SD memory card and inse

Page 4

1. Download the firmware file suitable for your PC after carefully reading the end-user licenseagreement, and save the file in your PC.The downloaded

Page 5

52. Open the FIRMWARE folder of the SD memory card to confirm that the FIRMWARE.BIN file hasbeen successfully copied.3. Disconnect the camera from the

Page 6 - How to update firmware

6Note: When performing the firmware update, use fully charged Lithium-ion Battery NP-1 orthe AC Adapter Set (sold separately). When using the AC Ada

Page 7

7How to update firmware5. The updating-completed message appears.Turn the camera off.6. Turn the camera on by pressing the main switch, toconfirm the

Page 8

810. When the confirmation screen appears, highlight“Yes” and press the center button of the controller.• In advance of using the prepared SD memory c

Commentaires sur ces manuels

Pas de commentaire

Minolta Dimage Dimage X Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour appareil photos de pont Minolta Dimage Dimage X. Minolta Dimage Dimage X Instruction manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour appareil photos de pont Minolta Dimage Dimage X