Minolta Maxxum Dynax 7 Manuel d'instructions télécharger pdf (Page 44)

8786

SETTING THE ISO MANUALLY

Continuous drive, exposure bracketing, multiple exposures, and

other options can be selected using the drive-mode lever.

The standard drive-mode setting for this

camera is single-frame (drive-mode lever

set to ).

The selectable modes are represented

by;

(Single-frame advance)

(Continuous advance)

Bracketing

S (Single frame advance)

C (Continuous advance)

Self-timer

Multiple Exposure

Set the ISO manually to override the DX-coded ISO or when using non-

DX coded film.

• Film must be loaded before the ISO can be changed.

• Non-DX coded film is initially set to the previous roll’s ISO.

1. Open the control-panel door

and press the ISO button.

• The current ISO is shown

in the display.

• The ISO can be changed

manually from 6 to 6400 in

1/3 EV increments.

2. Turn either control dial to set

the desired ISO value.

3. Press the shutter-release but-

ton partway down to enter the

new ISO.

Custom 4-2 DX Memory ON (p. 164).

Applies ISO changes to future rolls with the same DX-coded ISO.

• The drive-mode lever can not be changed while pressing the

exposure-mode dial lock-release button.

DRIVE

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 65 66

Pas de commentaire

Minolta Maxxum Dynax 7 Manuel d'instructions Page 44