Minolta DIMAGE SCAN ELITE Manuel d'instructions télécharger pdf (Page 87)

WHEN USING THE IEEE 1394 CABLE WITH WINDOWS ME

1 Quit the utility software.

2 Confirm the DiMAGE Scan Elite II indicator lamp is on and not blink-

ing.

• If other USB or IEEE devices are connected to the computer, confirm that they are not in

operation before continuing.

3 Double-click on the “Unplug or Eject Hardware” icon on the task bar.

• The unplug-or-eject-hardware dialog box will appear.

4 Select “Minolta DiMAGE Scan Elite 2” and click

“Stop”.

• A confirmation screen will appear.

5 On the confirmation screen, confirm the

device to be stopped. Click “OK” to stop the

device.

6 The “Safe to remove hardware” message

will confirm the operation. Click “OK” to fin-

ish.

7 Disconnect the cable.

• If the scanner is disconnected or turned off without fol-

lowing the above procedure, a message will appear to

indicate that the unsafe removal of device may cause

your computer to crash and lose valuable data. Click

“OK” and then check the image data.

APPENDIX

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 99 100

Pas de commentaire

Minolta DIMAGE SCAN ELITE Manuel d'instructions Page 87