Minolta Dimage 5 Manuel d'instructions télécharger pdf (Page 13)

24 25

CHANGING BATTERIES

BATTERY CONDITION INDICATORS

BASIC OPERATION

Open the battery-chamber door by moving the battery-

chamber lock to the open position .

Insert the batteries.

• Make sure the positive and negative battery terminals are

orientated as illustrated on the

diagram in the battery chamber.

This digital camera uses four AA-size alkaline batteries. AA-size Ni-MH batteries can

also be used, and are recommended because of longer life. When using Ni-MH

batteries, fully recharge them with a battery charger suitable for complex electronic

equipment. Please consult your vendor about an appropriate charger.

When replacing batteries, check that the mode dial is in the

off position.

Close the battery-chamber door and slide the lock lever to

the close position .

Full-battery Icon - The batteries are fully charged. This icon is

displayed for five seconds on the monitors when the camera is

turned on. The icon remains on the data panel.

Blinking low battery icon - When displayed on the data panel

with no other icons, power is insufficient for camera operation.

The shutter will not release. Replace the batteries immediately.

Low battery warning - Battery power is very low, but all

functions are operational. The batteries should be replaced as

soon as possible. This warning automatically appears and

remains on the display until the batteries are changed.

AUTO POWER SAVE

To conserve battery power, the camera will turn off displays and unnecessary functions

if an operation is not made within a certain period. The LCD monitor will turn off after

thirty seconds. The EVF and data panel turn off after one minute. To restore the

displays, press the shutter-release button partway down or press the display-

information button. The length of the auto-power-save period for the EVF and data

panel can be changed in the basic section of the setup menu (p. 114).

This camera is equipped with an automatic battery-condition indicator. When the

camera is on, the battery-condition indicator appears on the data panel and monitors.

The monitor icon will change from white to red when battery power is low. If the data

panel and monitors are blank, the batteries may be dead or installed incorrectly.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 74 75

Pas de commentaire

Minolta Dimage 5 Manuel d'instructions Page 13