Minolta Dimage 5 Manuel d'instructions télécharger pdf (Page 67)

DISCONNECTING THE CAMERA FROM THE COMPUTER

133132

DATA-TRANSFER MODE

WINDOWS ME AND WINDOWS 2000

Confirm that the access lamp is not lit. Turn the mode dial to another position and then

disconnect the USB cable.

Never disconnect the camera when the access lamp is lit - the data or

CompactFlash card may permanently be damaged.

To disconnect the camera, click once on the unplug-or-eject-hardware icon

located on the task bar. A small window will open indicating the device to

be stopped.

The hardware devices to be

stopped will be displayed.

Highlight the device by click-

ing on it then click “Stop.”

Confirm that the access lamp is not lit and then drag the mass-storage device icon and

drop it into the trash.

WINDOWS 98

When more than one external device are connected to the computer, the

unplug-or-eject-hardware window can be used. To disconnect the camera,

double click on the unplug-or-eject-hardware icon located on the task bar

to activate the window.

Click on the small window

to stop the device. The

safe-to remove-hardware

window will appear. Click

“OK.” Turn the mode dial to

another position and then

disconnect the USB cable.

A confirmation screen will appear to indicate the

devices to be stopped. Clicking “OK” will stop the

device.

A third and final screen will appear to indicate the

camera can be safely disconnected from the

computer. Turn the mode dial to another position

and then disconnect the USB cable.

Disconnect the USB cable.

• If the USB cable is disconnected before performing the first step, an alert message will

appear. Always complete the first step before disconnecting the USB cable.

MACINTOSH

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 73 74 75

Pas de commentaire

Minolta Dimage 5 Manuel d'instructions Page 67