Minolta DIMAGE A1 - SOFTWARE Manuel d'instructions télécharger pdf (Page 13)

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Changes or modifications not approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Tested by the Minolta Corporation 101 Williams Drive, Ramsey, New Jersey 07446, U.S.A.

Do not remove the ferrite cores from the cables.

This mark on your camera certifies that this camera meets the requirements of the EU

(European Union) concerning interference causing equipment regulations. CE stands

for Conformité Européenne (European Conformity).

Digital Camera:

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

This Class B digital apparatus complies with Canadian ICES-003.

The following marks may be found on the product:

DiMAGE A1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 48 49

Pas de commentaire

Minolta DIMAGE A1 - SOFTWARE Manuel d'instructions Page 13