Minolta CD-10 Manuel d'instructions télécharger pdf (Page 19)

Operating

5-2 Removing the PC card set

Make sure that the access indicator and lock indicator are not lit,

then press the eject button to release the PC card set.

When the access indicator is lit

In this case, the data is being read or written. Wait until the opera-

tions complete; then remove the card set. Removing a PC card or PC

card set during access operations will cause the data to be lost.

When the lock indicator is lit

The lock indicator differs between Macintosh and IBM PC/AT

platforms. Therefore, this section is divided into two parts;

Macintosh and IBM PC/AT.

For Macintosh: The lock indicator lights when the PC card set is

mounted. Dragging the PC card icon and dropping it onto the trash

icon ejects the PC card set, deletes the PC card icon and turns off the

lock indicator on this drive unit.

Do not remove a mounted PC card set. If removed, the following

message appears on the screen. Put the card set back into the slot.

Removing a mounted PC card or PC card set may damage the data stored

on it.

access indicator

lock indicator

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Pas de commentaire

Minolta CD-10 Manuel d'instructions Page 19