Minolta CD-10 Manuel d'instructions télécharger pdf (Page 27)

Troubleshooting

25

Cause

The power is not connected to an outlet or

computer.

Nonstandard SCSI cable is used.

The SCSI cable is too long.

The settings for the SCSI board are not ap-

propriate.

Loose connection in the SCSI connector.

The terminator is not activated.

The same SCSI ID is assigned to another

SCSI device.

A terminator is included in another hard

disk in a daisy chain connection.

EZ-SCSI is not installed.

ASPIDISK is not installed.

The card is not properly inserted.

Corrective Measure

Insert the power plug securely in an outlet

or computer.

Use a standard SCSI cable.

Use a standard SCSI cable (6m or less in

length).

Revise the settings according to the SCSI

board manual.

Plug in the SCSI connector again.

Activate the terminator.

Power off all the devices then change the

SCSI ID.

Remove the terminator or deactivate the

terminator on the CD-10

Install EZ-SCSI according to the EZ- SCSI

manual. Check the CONFIG.SYS file for

the proper setting.

Install ASPIDISK included in the attached

floppy disk.

Insert the card properly.

Symptom

The power will

not turn on.

The computer

hangs up at star-

tup.

The PC card

cannot be

recognized.

IBM PC/AT Systems

1 2 ... 22 23 24 25 26 27 28 29 30

Commentaires sur ces manuels

Pas de commentaire