Minolta Di183 Manuel de service Page 180

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 182
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 179
FrameMaker Ver.5.5E(PC) Di152/Di183 TROUBLESHOOTING
01.09.04
T-60
6. OTHER ERROR CODES
When an error that does not fall into the category of paper transport failure or malfunc-
tion, a corresponding error code is displayed in the Display.
Code Description Resetting Procedure
tnr Toner empty stop Change Toner Bottle.
nP Paper size is physically changed of
the paper source currently selected
for use while a copy cycle is being run.
Load paper of the size originally
loaded in the paper source being
used.
Turn OFF and ON the Power Switch.
Copier does not find paper of the
appropriate size when a copy cycle is
run using the ADF and in the Mixed
Original and Auto Paper mode.
Load the paper source with paper of
the appropriate size.
Turn OFF and ON the Power Switch.
oL Front Door, Right Door, or Side Door
is open.
Close the open door or lower the ADF.
oU ADF is raised.
oA ADF document take-up door is open.
H11 Scan image memory over Turn OFF and ON the Power Switch.
H2 The length of the paper set does not
match that of the paper actually taken
up and fed in.
Load paper of the correct size again
according to the set paper size.
Turn OFF and ON the Power Switch.
For copier tray: Slide out and in the
paper tray in which the size error has
occurred.
For Manual Bypass Tray: Place paper
in the Manual Bypass Tray.
For Multiple Bypass Tray: Unload
paper from the Multiple Bypass Tray,
then reload it back again.
H3 JS-202 exit capacity exceeded Remove paper that has been fed out.
J9 JS-202 Bin Switching Motor error (Job
Tray is unable to return to its home
position because paper left in the tray)
Remove paper from the tray.
Turn OFF and ON the Power Switch.
4022T505AA
4022T503AA
Vue de la page 179
1 2 ... 175 176 177 178 179 180 181 182

Commentaires sur ces manuels

Pas de commentaire